RCI F2164

• “Saw-tooth Adjustment Locator” design that allows the installer to move the deadbolt keeper, or plug and deadlatch ramp vertically to align with a wide variety of mortise locks with offset latches. There’s no need to order special faceplates, you can adjust the strike to work with virtualy any mortise lock type
• Up to 1500lbs (680kg) holding force
• Fits frame cutout for HES 1006 (1003)
• Accommodates ¾” latch projection
• Centerline faceplate included for centerline latch entry
• Horizontal adjustability up to 1/8″ (3mm) for misaligned frames
• Vertical Adjustability for precise deadbolt and latchbolt alignment
• Adjustable deadbolt keeper and deadlatch ramp
• Accommodates up to 1″ deadbolt (Night-latch function only, bolt will not release)
• Field selectable voltage input – Accommodates 12 or 24VDC and 12 to 24VAC. (24VAC is most common, emits ‘buzzing’ sound)
• Anti-tamper security screws
• All installation drivers included
• Low current draw (0.19 Amps @24VDC)
• “Cool Keeper” Solenoid located in house prevents keeper from heating up
• Plug-in wire connector
• Trim plate included
• Adhesive paper template included
• Non-handed
• Fail-locked (fail secure) mode standard. Note: Fail-unlocked (fail-safe) strikes are not permitted on fire labeled doors
• Optional Latch Monitor kit (available upon request).  May be added in the field if you decide you need monitoring at a later time… no need to buy another strike!

Certification

• UL 1034 Burglary Resistant Listed
• UL 10C (3 Hour) Fire Rated
• Factory tested to meet ANSI/BHMA 156.31 for strength and endurance

Warranty

• 5 Year Limited Warranty

The fail secure locking mechanism shall only be installed where allowed by the local authority having jurisdiction and shall not impair the operation of the panic hardware or intended operation of the emergency exit.